Skip to content Skip to sidebar Skip to footer

How To Reset Tire Pressure Light On 2011 Jeep Liberty

How To Reset Tire Pressure Light On 2011 Jeep Liberty. These were to include all passenger vehicles and light trucks with gwvr of. Also, if the light does not go off after you perform this procedure, then you will have to check and fill the spare tire to 33 psi to get the engine to shut off.

TPMS Reset Jeep Liberty 20052012 Tire Pressure Sensor
TPMS Reset Jeep Liberty 20052012 Tire Pressure Sensor from www.letsfixthatcar.com

Inflate all tires to pressure indicated on tire placard. I changed the wheels on it the tire pressure is good on all four tires. On my 2005 jeep liberty ltd.

Check All The Tires With A Pressure Gaugeand Fill Each Tire To 33 Psi When Cold (Not Right After Driving).


Purchased 2005 jeep liberty 9/29/05. The flash cycle will repeat every ten minutes or until the fault condition is removed and reset. Now hit the reset button that is to the right of the steering wheel and wait ten minutes.

If You Own An Old Model Without An Instrument Cluster, Press The Odometer Reset Button Until “Tire Learning Active” Message Is Displayed.


(1) lorna r july 16, 2020 to reset the tpms on the 2011 jeep liberty make sure the tire pressure is correct, then turn on the vehicle. Low tire pressure light came on for the first time indicating my back right tire was down to about 29psi. In some cases you may need to hold the button down till the light flashes.

In Some Cases You May Need To Hold The Button Down Till The Light Flashes.


Proper tire pressure for the jeep liberty is 33 psi for front and rear tires. To reset the tpms on the 2011 jeep liberty make sure the tire pressure is correct, then turn on the vehicle. How do i reset my tire pressure light on my jeep.

To Reset The 2010 Jeep Liberty Tpms Press And Release The Menu Button On The Console Multiple Times Until You Get To Reset Tire Sensor, Then Press The Step Button And Select Yes.


These were to include all passenger vehicles and light trucks with gwvr of. How do i reset my tire pressure light on my jeep check all the tires with a pressure gauge and fill each tire to 33 psi when cold (not right after driving). After reading some of the posts i increased all tires to 36 and it went off after just a few miles.

Using The Driver Instrument Cluster, Click The “Vehicle Information” Button And Navigate To “Relearn Tire Position”.


I have a 2011 jeep cherokee laredo and i need to reset the tpms. Start your vehicle and let it run for at least 20 minutes and your tpms system should be reset. Warning light didn't go off after two days of driving.

Post a Comment for "How To Reset Tire Pressure Light On 2011 Jeep Liberty"