How To Replace Temperature Sensor In Samsung Refrigerator
How To Replace Temperature Sensor In Samsung Refrigerator. To change the freezer's temperature, touch the freezerbutton. Usually the coolant temp sensor is used for the gauge for fuel trims for cold start enrichment, and fan control.
Usually the coolant temp sensor is used for the gauge for fuel trims for cold start enrichment, and fan control. Locate the thermistor in the refrigerator section; How to reset/change a samsung freezer temperature.
If It’s A Model That Has The Control Panel Inside, Make Sure You Turn Off The Child Lock.
Locate the control panel depending on the model of samsung refrigerator you own, it could either be inside the fridge or outside. Each time the fridge button is pressed, the temperature setting will change as follows; To reset or change a samsung freezer temperature, do the following… step 1:
Samsung Side By Side In Working Order For Now.thanks
Press the fridge button to switch the temperature between the presets available in your refrigerator's computer. The refrigerator temperature can be set in 2° increments between 34°f and 46°f. The user must have access to the back side of the fridge to access the back panel for this job.
Tap The O Button To Confirm.
Next replace sensor at the back of the fridge located on evaporator coil tube, next was to replace drain tube defroster ( must remove factory one by drilling out rivet) careful not to damage evap coil. This video is intended to give you the general idea of the part replacement procedure. Your appliance may differ depending on the manufacturer and model.
Since The Thermostat And Water Pump Are Mechanical The Engine Will Still Cool.
Release the thermistor cover and pull the thermistor out of the cover. The freezer temperature will change depending on the number of door openings, quantity of food, ambient temperature, etc. It’s under a small plastic cover attached to the surface of the back wall, side wall or ceiling.
Usually The Coolant Temp Sensor Is Used For The Gauge For Fuel Trims For Cold Start Enrichment, And Fan Control.
Next, insert your temperature sensor into a glass of ice water and give it a couple of minutes to cool down. It may take some time for the compartment to reach the set. The temperature sensor monitors the evaporator coil to check if it is frosted/iced over so that air cannot flow through it.
Post a Comment for "How To Replace Temperature Sensor In Samsung Refrigerator"