How To Replace Crankshaft Sensor On 1997 Jeep Grand Cherokee
How To Replace Crankshaft Sensor On 1997 Jeep Grand Cherokee. It is a hall effect swich, simply remove the distributor cap and the rotor and you can lift it out, unplug and replace. When the grand cherokee’s ecm determines that there is an issue with the signal coming from this sensor, it’ll throw the p0335 trouble code.
Various mechanics have been unable to diagnose, some have given up due to frustration. This information is transmitted to the engine computer, which then sets the ignition and fuel injector timing. Have fun but beware a bad crankshaft position sensor can cause a false cam sensor code to be set sometimes.
On Most Engines, The Sensor Is Attached With Two Bolts.
Have fun but beware a bad crankshaft position sensor can cause a false cam sensor code to be set sometimes. If the crankshaft position sensor is faulty, it will not transmit data accurately to the computer. The camshaft position sensor is located inside the distributor.
Now Go Back Inside The Jeep And Gently Pull On The String.
I have a 1997 jeep grand cherokee that stalls. Plug the one end back into the wire loom. Expert 5.2l and 5.9l engine the ckp sensor is bolted to the top of the cylinder block near the rear of the right cylinder head.
This Information Is Transmitted To The Engine Computer, Which Then Sets The Ignition And Fuel Injector Timing.
Changing the unit may seem simple at first. I have had the fuel pump replaced, the fuel system cleaned, the o2 sensor replaces, the water pump replaced, the crank sensor replaced, the map sensor replaced, and the ignition coil. Make sure that the plug end is extended towards the back of the engine or the sensor won't reach the hole.
It Is A Hall Effect Swich, Simply Remove The Distributor Cap And The Rotor And You Can Lift It Out, Unplug And Replace.
This sensor uses a reluctor to gauge the position of the crank. Installation is the reverse of removal. Cut the string off the old sensor and tie it to the new sensor.
After All, It Only Has One Or Two Bolts Or Nuts.
We just replaced the blower on our 1997 jeep grand cherokee tsi and it isn't getting power, we tested the resistor and it. Jeep grand cherokee crank sensor replacement. Still, depending on your particular jeep model, replacing the unit requires careful attention to details.
Post a Comment for "How To Replace Crankshaft Sensor On 1997 Jeep Grand Cherokee"