Best Location For Minn Kota Heading Sensor

Best Location For Minn Kota Heading Sensor. It is just a magnetic heading sensor it is simply to be installed on a flat surface, and by bluetooth design it's best within 20' and line of sight, but it will still work inside a rod locker but why? Regular spot lock works without it.

Minn Kota Heading Sensor with Bluetooth Overton's from www.overtons.com

The questions must be asked by you. So i bought the minn kota ultrex for my bass boat. The link below the button will open in a new tab.

Source: www.overtons.com

I was also told that it should not be hooked up to the trolling motor battery, hence mine is connected to the cranking one in the stern. So i bought the minn kota ultrex for my bass boat.

Source: www.thehulltruth.com

I was also told that it should not be hooked up to the trolling motor battery, hence mine is connected to the cranking one in the stern. Ideally, you should mount the minn kota heading sensor in a location where it has direct line of sight to the head of the trolling motor, and is at least 24 inches away from any magnetic or ferrous parts of your boat, as well as any batteries or wires.

Source: www.thehulltruth.com

You can also have the heading sensor repaired by an authorized service center. I just don't know where to mount it.

Source: www.fishraider.com.au

D1 most of the interference from the trolling motor comes down by the prop which is in the water. I just don't know where to mount it.

Source: www.technik-fuer-angler.de

Minn kota instructions indicate to not mount it closer than 24 from trolling motor, battery cables or ferrous metal source. It also minimises boat swing for a better hold.

Source: mbgforum.com

I didn't know if that would cause any interference. The mention of ferrous (iron/steel) or the trolling motor or power cables (magnetic fields.) not the bluetooth affected but the accuracy of the compass inside the heading sensor.

The Questions Must Be Asked By You.

Can you mount the sensor next to a lowrance carbon i have up on the bow? Mark the two screw holes’ locations to be used to secure the heading senor to the surface. This product can expose you to chemicals including di.

D1 Most Of The Interference From The Trolling Motor Comes Down By The Prop Which Is In The Water.

Minn kota instructions indicate to not mount it closer than 24 from trolling motor, battery cables or ferrous metal source. I have a tiller lund, so the sensor is on a bunk top next to the gunwale. Minn kota heading sensor installation on a crooked pilothouse boat.

Minn Kota Heading Sensor This This The Bluetooth Model To Improve Accuracy Of The Terrova, Ulterra And I Assume Ultrex But I Haven’t Looked That One Up.

The spot next to the carbon on the bow would be the best spot, but i don't want the sensor to be less effective because it's next to. The supreme strategy for minn kota heading sensor calibration. If playback doesn't begin shortly, try restarting your device.

The Link Below The Button Will Open In A New Tab.

I'm concerned with the amp draw of the sensor puck drawing one battery down more than the other causing problems. Basically, if you can lay your land down flat between the heading sensor and the trolling motor you should be fine. Software updates include a way.

I Can't Find What The Amp Draw Is For The Puck So I'm Coming Here To See If Anyone Else Has Done It This.

If you’re ready to accept all these issues and purchase one great fortune. I’m told the only thing its needed for is the jog feature of spot lock. Also yes minnkota will say it will enhance spot lock, because it lest you jog.