Jeep Wrangler Crank Position Sensor Location
Jeep Wrangler Crank Position Sensor Location. Click to see full answer. If your wrangler has this code, it means that the pcm (powertrain control module) has detected that the camshaft position circuit is sending an intermittent signal.
Tighten the mounting bolt (2) to 9 nm (80 in. Other causes are grounded/shorted/broken wire or. However>>>> the location for the crank angle sensor is the same for both.
A 2.5 Liter And A 4.0 Liter.
Jeep wrangelr crank position sensor. 2.5l and 4.0l engines have 2 plugs, 2 bolts to be handled. I have eliminated fuel pump and battery power and starter.
Tighten The Mounting Bolt (2) To 9 Nm (80 In.
Remove these 2 bolts, thereby, extract the sensor from the bell housing. Look directly below the transmission dipstick. The diagram only indicates the #12 location.
In The Above Pic Showing The Location, Imagine You're Standing At The Driver's Side Door, Facing The Passenger Side Headlight (So You're At An Angle).The Upper Left Of The Pic Is The Very Front Of The Jeep.just So You Have A Proper Orientation When You Go Look For It.
Other causes are grounded/shorted/broken wire or. I cant find the damn thing anywhere. In yj wrangler (4.0 / automatic), the sensor will use.
Details Of The Codes Belo.
Check if this fits your jeep wrangler. The camshaft sensor(s) is at the #12 location in the diagram at $39.88 each. There were two engines used in 1992 jeep wranglers.
Located Inside Distributor Body Or In Place Of Distributor) Oil Pressure Sensor (Lower Left Side Of The Engine Next To Oil Filter) Crankshaft Position Sensor (Ckp) (Located At The Rear Of Engine By The Transmission)
In the jeep wrangler yj & cherokee xj, it is located inside the distributor on both the 2.5l & 4.0l. There should be three prongs that go to the sensor, the one at the top is ground (i think) so use the left and right one., the three make a triange with the flat plastic plate inside the connector being the bottom. The two camshaft position sensors are located at the rear of the cylinder head covers.
Post a Comment for "Jeep Wrangler Crank Position Sensor Location"