Skip to content Skip to sidebar Skip to footer

Flame Sensor Vs Ignitor

Flame Sensor Vs Ignitor. Includes six brackets and accessories. A flame sensor on the other hand has a thin, may be white, electrical wire that goes from the flame sensing probe end and is plugged into the ignition control module.

Flame Sensor Igniter Long 40mm Bonaire 5011635sp
Flame Sensor Igniter Long 40mm Bonaire 5011635sp from www.totalgasspares.com.au

If the sensor detects that the burner has failed, it will turn off the gas. Once gas has ignited, the flame sensing circuitry will monitor the flame at the burner as long as it is powered to make sure that it is present. Flame sensors are used in modern furnaces that operate via an electronic ignition rather than a standing pilot light.

Flame Rods Depend On The Flame’s Ability To Conduct A Current When A Potential Is Applied Across It (Flame Ionization).


Glowfly universal hot surface igniter. The third video in the bryant gas pack series will feature the spark ignitor and the flame sensor. The hot surface ignitor means ignites fuel issuing from a fuel burner, and also acts as the flame rod or sensing means of a flame detecting system.

When Voltage Is Applied To A.


Not need of flame monitoring as the temperature can indicate if there is flame or not; In this hvac diagnosis video i go over the ignition troubleshooting of a smart valve, ignitor, and flame sensor by honeywell. Dual use of the igniter:

If, On The Other Hand, A Certain Period Of Time Elapses In Which The Flame Sensor Cannot Detect A Flame, It Will Automatically Shut Off The Gas Valve.


On such a system the oven will not light for 30 seconds after power is restored to the appliance. Electrodes and flame sensors are very economical, typically much lower cost than hot surface igniters. • disconnect the flame sensor wire from sensor.

Sn Igniter Are Very Robust


The most frequently cited advantage of dsi is cost. As the gas is ignited, the flame sensor creates a current of electricity. It's easy to tell the difference.

The Igniter Is Located In The Flow Of Gas Entering The Burners.


Unlike older furnaces that require an actual flame to operate, modern furnaces use an electronic ignition that has a hot surface ignitor. The flame sensor is able to detect the heat caused by combustion. A flame sensor on the other hand has a thin, may be white, electrical wire that goes from the flame sensing probe end and is plugged into the ignition control module.

Post a Comment for "Flame Sensor Vs Ignitor"