Reset Smartthings Water Sensor
Reset Smartthings Water Sensor. Tried 1 push, 3 pushes, etc and nothing. Try to pair it again…
About once per month, my zigbee sensors stop reporting to the hub. I do not mean connecting to the hub, but reset to dry from wet. The connect button must be held for five seconds.
If You Flip The Motion Sensor Over While Holding Down The Button, You’ll See A Light Turn From Orange To Red.
2 reset the sensor a. I’m using the “generic zigbee moisture sensor” device type with it. Your smartthings water leak sensor and other smart home brands can now work together seamlessly.
Great Battery Life, Detects Top And Bottom Water, Small Enough Not To Be Annoying But Not So Much I Lost It.
While the connect home is searching, press and hold the connect button on the water leak sensor for 5 seconds. It is powered by an included cr2 battery. Hold down the connect button (a) on the water leak sensor for 5 seconds.
Repeat This For All Sensors That Are Not Responding Or Showing Inaccurate Readings.
Tried 1 push, 3 pushes, etc and nothing. To fix these, i have to go around to each one, remove the battery for 10 seconds and then it works again. There’s a couple ways to do this, but the easiest way is to simply factory reset the device.
Release The Button When The Led Light Starts Blinking Red.
After a few months the sensor stopped reporting so i changed the battery. For anyone interested, i modified the st water leak device handler to work with the iris model. I do not mean connecting to the hub, but reset to dry from wet.
How Do I Reset My Smartthings Water Leak Sensor?
If the samsung smartthings water leak sensor won’t connect to your hub or detect moisture, you’ll want to reset the device. It reports temps fine, and i've confirmed everything is dry. Try to pair it again…
Post a Comment for "Reset Smartthings Water Sensor"